Home / Chemical Engineering / Fluid Mechanics :: Section 1

Chemical Engineering :: Fluid Mechanics

  1. With increasing flow rate, the hydraulic efficiency of a centrifugal pump

  2. A.
    monotonically decreases.
    B.
    decreases and then increases.
    C.
    remains constant.
    D.
    increases and then decreases.

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The velocity profile for turbulent flow through a closed conduit is

  4. A.
    logarithmic
    B.
    parabolic
    C.
    hyperbolic
    D.
    linear

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. In case of hydraulically smooth pipe, the resistance to flow depends only on the Reynolds number, whereas for a hydraulically rough pipe, the resistance to flow is governed by the relative roughness. Two pipes are said to have the same hydraulic roughness, when they have equal values of

  6. A.
    relative roughness.
    B.
    absolute roughness.
    C.
    friction co-efficient for flows at equal Reynold number.
    D.
    all (a), (b) & (c).

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Water hammer in a pipeline results from the

  8. A.
    bursting of pipelines due to closure by a valve.
    B.
    rapid pressure change due to a rapid change in the rate of flow.
    C.
    pressure increase due to closure of a valve resulting in decrease in rate of flow.
    D.
    none of these.

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Molten soap mass is transported by a __________ pump.

  10. A.
    diaphragm
    B.
    reciprocating
    C.
    gear
    D.
    centrifugal

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. Which of the following denotes the effect of compressibility in fluid flow ?

  12. A.
    Weber number
    B.
    Mach number
    C.
    Euler number
    D.
    Reynolds number

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. Nominal size of the discharge pipe of a pump is usually __________ the nominal size of the inlet pipe.

  14. A.
    smaller than
    B.
    larger than
    C.
    same as
    D.
    twice

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. The terminal velocity of a small sphere settling in a viscous fluid varies as the

  16. A.
    first power of its dimeter.
    B.
    inverse of the fluid viscosity.
    C.
    inverse square of the diameter.
    D.
    square of the difference in specific weights of solid & fluid.

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. If the discharge of a centrifugal pump is throttled, then its suction lift

  18. A.
    increases
    B.
    decreases
    C.
    remains unchanged
    D.
    data insufficient to predict

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. Foot valves provided in pumps are __________ valves.

  20. A.
    relief
    B.
    three/four way
    C.
    pressure reducing
    D.
    directional control

    View Answer

    Workspace

    Discuss Discuss in Forum