Home / Civil Engineering / UPSC Civil Service Exam Questions :: Section 14

Civil Engineering :: UPSC Civil Service Exam Questions

  1. If the stress on the cross-section of a circular short column of diameter D is to be wholly compressive, the load should be applied within a concentric circle of diameter

  2. A.
    D/2
    B.
    D/8
    C.
    D/4
    D.
    D/6

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. What does higher standard deviation imply in cost analysis ?

  4. A.
    Higher uncertainty
    B.
    Lower uncertainty
    C.
    Nothing to do with uncertainty
    D.
    Extra costs are likely

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Consider the following statements :
    The disease of dry not in timber is caused by :
    1. complete submergence in water.
    2. alternate wet and dry condition.
    3. lack of ventilation.
    Which of the statements given above is/are correct ?

  6. A.
    1 only
    B.
    3 only
    C.
    2 only
    D.
    2 and 3

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. A section of a flitched beam is shown in the given figure. The main role of the steel plate placed between the two timber sections is to

  8. A.
    increase the axial resistance of the section
    B.
    increase and density
    C.
    increase shear and bending resistance of the section
    D.
    avoid development of shear stress in the two timber sections

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. A velocity field with no components in the y and z directions is given by V = 6 + 2xy +t2
    The acceleration along the x-direction at a point (3, 1, 2), at time 2, is

  10. A.
    8 units
    B.
    16 units
    C.
    28 units
    D.
    36 units

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. For stream function ψ = 3x2 - y3, the magnitude of velocity at the point (2, 1) is

  12. A.
    12.37
    B.
    12
    C.
    13
    D.
    13.5

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. Consider the following statements about provision of sag rods :
    1. Sag rods reduce span length of purlin in the weak direction.
    2. Sag rods are installed in the plane of the roof.
    3. Ridge purlin is subject to vertical components of sag rods on either side of slope.
    Which of the statements given above are correct ?

  14. A.
    1, 2 and 3
    B.
    2 and 3
    C.
    1 and 2
    D.
    1 and 3

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. The smallest scale adopted for topographical surveys is

  16. A.
    1 : 25, 000
    B.
    1 : 50, 000
    C.
    1 : 2, 50, 000
    D.
    1 : 5, 00, 000

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. A shot of mass m penetrates a thickness t of a fixed plate of mass M. If the plate were free to move and the resistance supposed to be uniform, which one of the following is the thickness penetrated ?

  18. View Answer

    Workspace

    Discuss Discuss in Forum


  19. Which one of the following gives the number of gate position in an airport ?

  20. View Answer

    Workspace

    Discuss Discuss in Forum