Home / Civil Engineering / UPSC Civil Service Exam Questions :: Section 27

Civil Engineering :: UPSC Civil Service Exam Questions

  1. A fixed beam of unifrom section is carrying a point load at its mid-span. If the moment of inertia of the middle half length is now reduced to half its previous value, then the fixed end moments will

  2. A.
    Increase
    B.
    decrease
    C.
    remain constant
    D.
    change their directions

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The moisture content of a clayey soil is gradually decreased from a large value. What will be the correct sequence of the occurrence of the following limits ?
    1. Shrinkage limit
    2. Plastic limit
    3. Liquid limit
    Select the correct answer from the codes given below :

  4. A.
    1, 2, 3
    B.
    1, 3, 2
    C.
    3, 2, 1
    D.
    3, 1, 2

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. For the movement of vehicles at an intersection of two roads without any interference, which type of grade separation is generally preferred ?

  6. A.
    Delta
    B.
    Diamond
    C.
    Trumpet
    D.
    Cloverleaf

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Which one of the following stresses is independent of yield stress as a permissible stress for steel members ?

  8. A.
    Axial tensile stress
    B.
    Maximum shear stress
    C.
    Bearing stress
    D.
    Stress in slab base

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Permissible limit of cant deficiency for Broad Gauge (B.G.) is

  10. A.
    50 mm
    B.
    60 mm
    C.
    75 mm
    D.
    88 mm

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. If the line of sight between two stations A and B, on sea, and 80 km apart, makes tangent at point A, then the minimum elevation of the signal required at B (considering the coefficient of refraction "m" = 0.08 and the mean radius of earth as 6400 km) will be

  12. A.
    42 m
    B.
    210 m
    C.
    420 m
    D.
    840 m

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. A simply supported beam of uniform cross-section is subjected to a maximum bending moment of 2.25 t.m. If it has rectangular cross-section with width 15 cm and depth 30 cm, then the maximum bending stress induced in the beam will be

  14. A.
    50 kg/cm2
    B.
    100 kg/cm2
    C.
    150 kg/cm2
    D.
    225 kg/cm2

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Consider the following statements regarding underreamed piles :
    1. They are used in expansive soils.
    2. They are of perkcast reinforced concrete.
    3. The ratio of bulb to shaft diameters is usually 2 to 3.
    4. Minimum spacing between the piles should not be less than 1.5 times the bulb diameter.
    of these statements :

  16. A.
    1, 2 and 3 are correct
    B.
    1, 3 and 4 are correct
    C.
    2, 3 and 4 are correct
    D.
    1, 2 and 4 are correct

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. What is efflorescence ?

  18. A.
    Formation of white patches on the brick surface due to insoluble salts in the brick clay
    B.
    Swelling of brick due to presence of carbonaceous matter and gas
    C.
    Deformation of brick due to exposure to rain
    D.
    Impurities in the brick clay which show after burning

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. Consider the following statements regarding a beam of uniform cross-section simply supported at its ends and carrying a concentrated load at one of its third points :
    1. Its deflection under the load will be maximum.
    2. The bending moment under the load will be maximum.
    3. The deflection at the mid-point of the span will be maximum.
    4. The slope at the nearer support will be maximum.
    Of these statements :

  20. A.
    1 and 3 are correct
    B.
    2 and 4 are correct
    C.
    1 and 2 are correct
    D.
    3 and 4 are correct

    View Answer

    Workspace

    Discuss Discuss in Forum