Home / CSE / Automation System :: Section 1

CSE :: Automation System

  1. Flat panel displays are based on what type of technology?

  2. A.
    Direct view storage tube
    B.
    Very large-scale integration (VLSI)
    C.
    Solid state
    D.
    RGB monitor
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. Which of the following is a graphical input device?

  4. A.
    light pen
    B.
    keyboard
    C.
    mouse
    D.
    Track ball
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Today, programmable controllers:

  6. A.
    are more powerful then the first controllers on the market
    B.
    are relatively low cost compared with the original digital equipment available for industrial control
    C.
    can be cost effective even when replacing just a few relays
    D.
    All of the above
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Productivity is defined as:

  8. A.
    number of items manufactured per day
    B.
    output per man-hour of labour
    C.
    cost per day
    D.
    cost per unit
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. The main function(s) of computer in CAD is/are

  10. A.
    To serve as an extension to the memory of the designer
    B.
    To enhance the analytical and logical power of the designer
    C.
    To relieve the designer from routine repetitious tasks.
    D.
    All of the above
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. The first industrial robot for commercial uses was installed in a Japanese plant at Toyota Automatic Loom Company, the parent company of the Toyota Automobile Group. When did this robot go into operation?

  12. A.
    June 1965
    B.
    November 1966
    C.
    December 1967
    D.
    April 1970
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. What is the difference between integral and derivative control?

  14. A.
    derivative control does not eliminate offset error
    B.
    integral control has slower response to an error signal.
    C.
    derivative control responds to a change in the rate of change in the error signal
    D.
    All of the above
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. The program counter:

  16. A.
    decides which program to run
    B.
    counts the number of instructions that have been executed
    C.
    contains the address of the next instruction to be executed
    D.
    is where arithmetic is done in a computer.
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. Digital signals:

  18. A.
    can have three possible levels
    B.
    are assigned values of 1 or 0 depending on the voltage level
    C.
    have a sinusoidal shape.
    D.
    have a frequency measured in units of hertz
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. There are several procedures you can implement to provide maximum security. The most important of these is:

  20. A.
    do not leave training manuals unsecured
    B.
    run regular simulated tests using TARP (testing of Applications Recovery Planes)
    C.
    Verify the reputation of the people installing your system
    D.
    do not allow unbonded service people to work on your equipment
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum