Home / CSE / Automation System :: Section 4

CSE :: Automation System

  1. The processing, which normally consists of a small computer with one or more peripheral devices, connected via a high-speed line to the large control computer is known as

  2. A.
    On-line processing
    B.
    Remote-terminal processing
    C.
    Batch mode processing
    D.
    Intelligent terminal Processing
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. VLSI (very large scale integrated circuits) logic:

  4. A.
    will not be available in this decade
    B.
    means more costly electronic products in the future
    C.
    will result in lower cost, higher capability electronic equipment
    D.
    All of the above
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. The term used to represent the recycling of unused memory is:

  6. A.
    garbage collection
    B.
    diagnostic routine
    C.
    memory dump
    D.
    direct memory access
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. In the instruction, 500 SUBA # 50 the command field is:

  8. A.
    500
    B.
    # 50000
    C.
    SUBA
    D.
    (b) and (c)
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Use of modern control technology in automation systems:

  10. A.
    reduces costs
    B.
    improves reliability
    C.
    increases yield
    D.
    All of the above
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. One of the major benefits of using CAD in tool design is that:

  12. A.
    product design represents approximately one-half the engineering costs
    B.
    tool motions can be checked to see if there is interference between the tool and the object
    C.
    there is better coordination in the materials-handling area
    D.
    it simplifies the trial-and-error method
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. The speed at which the monitor accepts data is called:

  14. A.
    bandwidth
    B.
    response time
    C.
    interlacing
    D.
    scanning
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. The chosen language for the Japanese Fifth-Generation Compu¬ter Project is:

  16. A.
    LISP
    B.
    FORTRAN
    C.
    COBOL
    D.
    PROLOG
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. When a computer fetches an instruction, the binary code representing the instruction appears on the:

  18. A.
    I/O address bus
    B.
    memory data bus
    C.
    input data bus
    D.
    output data bus
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. A stepping motor;

  20. A.
    has a speed proportional to voltage input
    B.
    has a commutator
    C.
    is a good choice where continuous rotation is needed
    D.
    can index positional movement.
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum