Home / CSE / Computer Hardware :: Section 1

CSE :: Computer Hardware

  1. The 34-pin connection on an I/O card is for?

  2. A.
    Floppy drive
    B.
    SCSI drive
    C.
    IDE drive
    D.
    Zip drive
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The terms "red book", "yellow book", and "orange book" refer to:

  4. A.
    SCSI
    B.
    ide
    C.
    floppy drive technology
    D.
    CD-ROM standards
    E.
    All of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. On the 16-bit ISA bus, IRQ2 is elevated to which higher level Interrupt?

  6. A.
    9
    B.
    11
    C.
    13
    D.
    15
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. What beep codes could indicate a system board or power supply failure?

  8. A.
    steady short beep
    B.
    no beep
    C.
    one long continuous beep tone
    D.
    steady long beeps
    E.
    All of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. To view any currently running Terminate Stay Resident (TSR's) programs you could type:

  10. A.
    Memory
    B.
    MEM
    C.
    SYS /M
    D.
    Memmaker
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. Which part of the laser printer should NOT be exposed to sunlight?

  12. A.
    Transfer corona assembly
    B.
    PC drum
    C.
    Primary corona wire
    D.
    Toner cartridge
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. After doing a low-level format, what would be the next step in configuring the hard drive in a system?

  14. A.
    Format DOS partition
    B.
    Install operating system
    C.
    Configure DMA channel and back-up interrupt
    D.
    Partition had disk
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Resistance is measured in ?

  16. A.
    Volts
    B.
    Amps
    C.
    Watts
    D.
    Ohms
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. What command is used to reset a MODEM when using the "AT Command Set"?

  18. A.
    ATR
    B.
    ATZ
    C.
    DTR
    D.
    DCE
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to:

  20. A.
    B0007
    B.
    An unused SCSI address
    C.
    The same address as the SCSI device before the CD-ROM
    D.
    SCSI ID=1
    E.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum