Home / ECE / Communication Systems :: Section 4

ECE :: Communication Systems

  1. A directional microphone gives an output of 0.5 mV whereas an omnidirectional one gives an output of 0.5 μV in the same position for the same sound pressure. The directivity of the directional microphone is

  2. A.
    120 dB
    B.
    90 dB
    C.
    60 dB
    D.
    30 dB

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. If Eb, the energy per bit of a binary digital signal is 10-6 watt sec. and the one sided power spectral density of the white noise N0 = 10-5 W/Hz, then the output SNR of the matched filter is

  4. A.
    26 dB
    B.
    10 dB
    C.
    20 dB
    D.
    13 dB

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Consider the following statements about Rhombic antenna

    1. It is non resonant
    2. It is a broad band antenna
    3. It is ideally suited for HF transmission
    Which of the above are correct?

  6. A.
    1, 2, 3
    B.
    1, 3 only
    C.
    2, 3 only
    D.
    1 only

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Assertion (A): A composite video signal has synchronising pulses.

    Reason (R): It is necessary to synchronise the scanning process in the transmitter and receiver.

  8. A.
    Both A and R are correct and R is correct explanation of A
    B.
    Both A and R are correct but R is not correct explanation of A
    C.
    A is correct but R is wrong
    D.
    A is wrong but R is correct

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Noise with uniform power spectral density of N0ω/Hz is passed through a filter H(ω) = 2 exp (-J ω ty) followed by an ideal low pass filter of bandwidth B Hz. The output noise power in watts is

  10. A.
    2 N0B
    B.
    4 N0B
    C.
    8 N0B
    D.
    16 N0B

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. Assertion (A): In standing wave pattern, the nodes and anti nodes are separated by half wave-length

    Reason (R): When line is terminated in resistance RL, the standing wave ratio is SWR = Z0/RL or RL/Z0

  12. A.
    Both A and R are correct and R is correct explanation of A
    B.
    Both A and R are correct but R is not correct explanation of A
    C.
    A is correct but R is wrong
    D.
    A is wrong but R is correct

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. An amplifier has an input resistance of 10 kΩ and the noise voltage is 10 μV. If two such resistances of 10 kΩ each are connected in series at the input, the total noise voltage is about

  14. A.
    20 μV
    B.
    5μV
    C.
    14.14 μV
    D.
    10 μV

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. A 400 W carrier is modulated to a depth of 75 percent. The total power in modulated wave will be

  16. A.
    38.5 W
    B.
    400 W
    C.
    512.5 W
    D.
    615.5 W

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. In a colour TV receiver the bandwidth of RF amplifier is

  18. A.
    exactly equal to channel width
    B.
    a little less than channel width
    C.
    a little more than channel width
    D.
    either (a) or (b)

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. An FM signal with a deviation is passes through the mixer, and has its frequency reduced five fold. The deviation in the output of the mixer is

  20. A.
    Δ
    B.
    C.
    Δ/5
    D.
    indeterminant

    View Answer

    Workspace

    Discuss Discuss in Forum