Home / ECE / Communication Systems :: Section 23

ECE :: Communication Systems

  1. The diagonal clipping in Amplitude Demodulation using (envelope detector) can be avoided if Rc time constant of the envelope detector satisfies the following condition here ω is message bandwidth and ωc is carrier frequency both in rad sec,

  2. View Answer

    Workspace

    Discuss Discuss in Forum


  3. To select one out of N equally probable events, the number of bits required is

  4. A.
    log2 N
    B.
    log10 N
    C.
    loge N
    D.
    N

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. What is the frequency of audio modulation?

  6. A.
    1000 Hz
    B.
    2000 Hz
    C.
    3000 Hz
    D.
    2000 kHz

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. The RF section of a radio transmit generally consists of

  8. A.
    master oscillator
    B.
    final power amplifier to feed antenna
    C.
    buffer stage
    D.
    all of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. The storage capacity of audio CD is 540 Mb per side.

  10. A.
    True
    B.
    False

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. In case of a low level AM transmitter, the amplifier modulated stage must be

  12. A.
    class A
    B.
    class B
    C.
    class B (linear)
    D.
    class C

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. The device most likely to be found in an SSB transmitter is

  14. A.
    class C audio amplifier
    B.
    tuned modulator
    C.
    class B RF amplifier
    D.
    class A RF amplifier

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Point out the false statement

  16. A.
    impulse noise voltage does not depend on bandwidth
    B.
    thermal noise is independent of frequency at which it is measured
    C.
    industrial noise is mostly of impulse type
    D.
    space noise is observable at frequencies in the range of 8 MHz and higher

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. In a low level AM system, the modulated amplifiers stage must be

  18. A.
    harmonic devices
    B.
    non-linear devices
    C.
    class C amplifier
    D.
    linear devices

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. An angle modulated signal is expressed by fa(t) = cos (2 x 108 pt) + 75 sin (2 x 103 pt). The peak frequency deviation of the carrier is

  20. A.
    1 kHz
    B.
    7.5 kHz
    C.
    75 kHz
    D.
    100 MHz

    View Answer

    Workspace

    Discuss Discuss in Forum