ECE :: Matching Questions
-
Match the following:
List I (Devices) List II (characteristic) A. BJT 1. Voltage controlled negative resistance B. MOSFET 2. High current gain C. Tunnel diode 3. Voltage regulation D. Zener diode 4. High input impedance
-
Match the following:
List I (I/P - O/P relation) List II (Property of the system) A. y(n) = x(n) 1. Nonlinear, non-causal B. y(n) = x(n2) 2. Linear, non casual C. y(n) = x2(-n) 3. Linear causal D. y(n) = x2(n) 4. Nonlinear causal
-
Match the following:
List I List II A. ∇ x = 0 1. irrotational vector B. ∇ . = 0 2. conservative field C. ∮ .dl = 0 3. solenoidal vector
-
Match the following:
List I List II A. Detection of a periodic signal in noise 1. Increase in band-width B. Recovery of a band limited signal from its uniformly sampled values 2. Slope over load error C. Finer quantization 3. Nyquist rate of signals D. Delta modulation 4. Cross correlation
-
List I (Parameters) List II (Values) A. h22 1. rb + re B. h11 2. acb C. h21 3.
-
Match the following:
List I List II A. Sky wave 1. parasitic elements B. Antenna feed 2. delta match C. Reflector 3. long-wire antenna D. Rhombic antenna 4. ionosphere
-
Match the following:
List I (Camera pick up tubes) List II (Special feature) A. Vidicon 1. Highest sensitivity B. Plumbicon 2. Temperature sensitive C. Saticon 3. Large lag D. New vicon 4. Special target for red response
-
Match the following:
List I (Modes) List II (Characteristic) A. Evanescent 1. Rectangular waveguide does not support B. Dominant mode 2. No wave propagation C. TM10 and TM01 3. Lowest cut-off frequency
-
Match the following:
List I List II A. Servomotor 1. Error detector B. Amplidyne 2. Transducer C. Potentiometer 3. Actuator D. Flapper valve 4. Power amplifier
-
Match the following:
List I (Types of memory) List II (Used As) A. DRAM 1. Cache memory B. SRAM 2. Main memory C. Parallel Access Registers 3. BIOS memory D. ROM 4. CPU registers