Home / ECE / Power Electronics :: Section 4

ECE :: Power Electronics

  1. In brushless excitation system of modern alternators, the main exciter is

  2. A.
    dc generator
    B.
    ac generator
    C.
    either dc or ac generator
    D.
    induction generator

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The two-transistor model of a thyristor consists of two transistors :

  4. A.
    one n-p-n and other p-n-p
    B.
    both p-n-p
    C.
    both n-p-n
    D.
    one n-p-n and other UJT

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. In a thyristor, the forward breakover voltage

  6. A.
    is constant
    B.
    may be constant or may depend on gate current
    C.
    decreases as gate current is increased
    D.
    increases as gate current is increased

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. The gate lead, in a thyristor is welded to :

  8. A.
    p layer to which anode is connected
    B.
    n layer nearest to the anode terminal
    C.
    p layer nearest to the cathode terminal
    D.
    outside n layer

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. In a 3 phase full converter, the firing angle is less than 60°. The instantaneous output voltage

  10. A.
    will have positive part only
    B.
    will have both positive and negative parts
    C.
    may have both positive and negative parts
    D.
    will have negative part if load is inductive

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. In a stud mounted SCR, the stud is

  12. A.
    in thermal contact with heat sink
    B.
    insulated from heat sink
    C.
    in electrical and thermal contact with heat sink
    D.
    in either electrical or thermal contact with heat sink

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. In pulse width modulation of chopper

  14. A.
    T is kept constant and Ton is varied
    B.
    Ton is kept constant T is varied
    C.
    both T and Ton are varied
    D.
    either T or Ton is varied

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. In a full bridge inverter, the waveshape of load current depends on

  16. A.
    relative values of load parameters R, L and C
    B.
    relative values of load parameters R and L
    C.
    relative values of load parameters L and C
    D.
    gating frequency

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. The characteristics of which device has peak point and valley point

  18. A.
    SCR
    B.
    PUT
    C.
    SCS
    D.
    Shockley diode

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. In a step down chopper using time ratio control, the input voltage is V and duty cycle is a. The load is purely resistive having resistance R. The average and rms load currents are

  20. View Answer

    Workspace

    Discuss Discuss in Forum