Home / EEE / Polyphase Induction Motors :: section-1

EEE :: Polyphase Induction Motors

  1. An induction motor can run at synchronous speed when

  2. A.

     It is run on load

    B.

     It is run in reverse direction

    C.

     It is run on voltage higher than the rated voltage

    D.

     e.m.f. is injected in the rotor circuit

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. Slip ring motor is preferred over squirrel cage induction motor where

  4. A.

     High starting torque is required

    B.

     Load torque is heavy

    C.

     Heavy pull out torque is required

    D.

     All of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. A change of 4% of supply voltage to an induction motor will produce a change of approximately

  6. A.

     4% in the rotor torque

    B.

     8% in the rotor torque

    C.

     12% in the rotor torque

    D.

     16% in the rotor torque

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. If an induction motor with certain ratio of rotor to stator slots, runs at 1/7 of the normal speed, the phenomenon will be termed as

  8. A.

     Humming

    B.

     Hunting

    C.

     Crawling

    D.

     Cogging

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. The 'cogging' of an induction motor can be avoided by

  10. A.

     Proper ventilation

    B.

     Using DOL starter

    C.

     Autotransformer starter

    D.

     Having number of rotor slots more or less than the number of stator slots (not equal)

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. The power scale of circle diagram of an induction motor can be found from

  12. A.

     Stator resistance test

    B.

     No-load test only

    C.

     Short-circuit test only

    D.

     None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. In a three-phase induction motor, the number of poles in the rotor winding is always

  14. A.

     Zero

    B.

     More than the number of poles in stator

    C.

     Less than number of poles in stator

    D.

     Equal to number of poles in stator

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Which type of bearing is provided in small induction motors to support the rotor shaft?

  16. A.

     Ball bearings

    B.

     Cast iron bearings

    C.

     Bush bearings

    D.

     None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. The vafcie of transformation ratio of an induction motor can be found by

  18. A.

     Open-circuit test only

    B.

     Short-circuit test only

    C.

     Stator resistance test

    D.

     None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. An induction motor is identical to

  20. A.

     D.C. compound motor

    B.

     D.C. series motor

    C.

     Synchronous motor

    D.

     Asynchronous motor

    View Answer

    Workspace

    Discuss Discuss in Forum