Home / EEE / Power Plant Engineering in EE :: section-1

EEE :: Power Plant Engineering in EE

  1. The amount of air which is supplied for complete combustion is called

  2. A.

     primary air

    B.

     secondary air

    C.

     tertiary air

    D.

     none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. Reheat factor is the ratio of

  4. A.

     isentropic heat drop to useful heat drop

    B.

     adiabatic heat drop to isentropic heat drop

    C.

     cumulative actual enthalpy drop for the stages to total is isentropic enthalpy heat drop

    D.

     none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Curtis turbine is

  6. A.

     reaction steam turbine

    B.

     pressure velocity compounded steam turbine

    C.

     pressure compounded impulse steam turbine

    D.

     velocity compounded impulse steam turbine

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Mercury is a choice with steam in binary vapour cycle because it has

  8. A.

     higher critical temperature and pressure

    B.

     higher saturation temperature than other fluids

    C.

     relatively low vapourisation pressure

    D.

     all above

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. In regenerative cycle feed water is heated by

  10. A.

     exhaust gases

    B.

     heaters

    C.

     draining steam from the turbine

    D.

     all above

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. The energy radiated by sun on a bright sunny day is approximately

  12. A.

     700 W/m²

    B.

     800 W/m²

    C.

     1 kW/m²

    D.

     2 kW/m²

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. The average ash content in Indian co als is about

  14. A.

     5%

    B.

     10%

    C.

     15%

    D.

     20%

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. The main source of production of biogas is

  16. A.

     human waste

    B.

     wet cow dung

    C.

     wet livestock waste

    D.

     all above

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. Deaerative heating is done to

  18. A.

     Heat the water

    B.

     Heat the air in the water

    C.

     Remove dissolved gases in the water

    D.

     None of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. Regenerative cycle thermal efficiency

  20. A.

     is always greater than simple Rankine thermal efficiency

    B.

     is greater than simple Rankine cycle thermal efficiency only when steam is bled at particu-lar pressure

    C.

     is same as simple Rankine cycle thermal efficiency

    D.

     is always less than simple Rankine cycle thermal efficiency

    View Answer

    Workspace

    Discuss Discuss in Forum