Home / EEE / Transformers :: General Questions 1

EEE :: Transformers

  1. If R₂ is the resistance of secondary winding of the transformer and K is the transformation ratio then the equivalent secondary resistance referred to primary will be

  2. A.

     R₂/√K

    B.

     R₂/K²

    C.

     R₂²/K²

    D.

     R₂²/K

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. Two transformers operating in parallel will share the load depending upon their

  4. A.

     leakage reactance

    B.

     per unit impedance

    C.

     efficiencies

    D.

     ratings

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Which of the following does not change in an ordinary transformer?

  6. A.

     Frequency

    B.

     Voltage

    C.

     Current

    D.

     Any of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. When a given transformer is run at its rated voltage but reduced frequency, its

  8. A.

     flux density remains unaffected

    B.

     iron losses are reduced

    C.

     core flux density is reduced

    D.

     core flux density is increased

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Which of the following does not change in a transformer?

  10. A.

     Current

    B.

     Voltage

    C.

     Frequency

    D.

     All of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. The starting torque of a squirrel-cage induction motor is

  12. A.

     low

    B.

     negligible

    C.

     same as full-load torque

    D.

     slightly more than full-load torque

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. While conducting short-circuit test on a transformer the following side is short circuited

  14. A.

     High voltage side

    B.

     Low voltage side

    C.

     Primary side

    D.

     Secondary side

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. During short circuit test iron losses are negligible because

  16. A.

     the current on secondary side is negligible

    B.

     the voltage on secondary side does not vary

    C.

     the voltage applied on primary side is low

    D.

     full-load current is not supplied to the transformer

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. If a transformer is continuously operated the maximum temperature rise will occur in

  18. A.

     core

    B.

     windings

    C.

     tank

    D.

     any of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. The primary coil of a transformer is connected to a 60 V ac source. The secondary coil is connected to a 330 Ω load. The turns ratio is 3:1. What is the secondary voltage?

  20. A.

     2 V

    B.

     20 V

    C.

     180 V

    D.

     18 V

    View Answer

    Workspace

    Discuss Discuss in Forum