Home / Mechanical Engineering / Refrigeration and Air Conditioning :: section-1

Mechanical Engineering :: Refrigeration and Air Conditioning

  1. In vapour compression cycle, the condition of refrigerant is high pressure saturated liquid

  2. A.

     After passing through the condenser

    B.

     Before passing through the condenser

    C.

     After passing through the expansion or throttle valve

    D.

     Before entering the expansion valve

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. In a vapour compression system, the condition of refrigerant is dry saturated vapour

  4. A.

     Before entering the compressor

    B.

     After leaving the compressor

    C.

     Before entering the condenser

    D.

     After leaving the condenser

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. In vapour compression cycle the condition off refrigerant is dry saturated vapour

  6. A.

     After passing through the condenser

    B.

     Before passing through the condenser

    C.

     After passing through the expansion or throttle valve

    D.

     Before entering the compressor

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. The refrigerant used in small tonnage commercial machines (hermetically sealed units) is

  8. A.

     Ammonia

    B.

     Carbon dioxide

    C.

     Sulphur dioxide

    D.

     R-12

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. The refrigeration effect in a dry evaporator compared to flooded evaporator in a similar plant is

  10. A.

     Same

    B.

     More

    C.

     Less

    D.

     More or less depending on ambient conditions

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. Highest pressure encountered in a refrigeration system should be

  12. A.

     Critical pressure of refrigerant

    B.

     Much below critical pressure

    C.

     Much above critical pressure

    D.

     Near critical pressure

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. In a vapour compression system, the condition of refrigerant before passing through the condenser is

  14. A.

     Saturated liquid

    B.

     Wet vapour

    C.

     Dry saturated vapour

    D.

     Superheated vapour

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Which of the following cycles uses air as the refrigerant?

  16. A.

     Ericson

    B.

     Stirling

    C.

     Carnot

    D.

     Bell Coleman

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. The heat rejection factor (HRF) is given by

  18. A.

     1 + C.O.P

    B.

     1 - C.O.P.

    C.

     1 + (1/C.O.P)

    D.

     1 - (1/C.O.P)

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. In a spray washing system, if the temperature of water is higher than the dry bulb temperature of entering air, then the air is

  20. A.

     Heated and dehumidified

    B.

     Heated and humidified

    C.

     Cooled and humidified

    D.

     Cooled and dehumidified

    View Answer

    Workspace

    Discuss Discuss in Forum