Home / Chemical Engineering / Chemical Engineering Basics :: Section 13

Chemical Engineering :: Chemical Engineering Basics

  1. Maraging steels derive their strength from the following mechanism:

  2. A.
    A fine, highly dislocated and strong martensite.
    B.
    Fine dispersions of intermetallics of Fe, Ni, Ti etc.
    C.
    Fine dispersions of alloy carbides in a ferrite matrix.
    D.
    Fine dispersions of Fe3 C nucleated on dislocations in austenite.

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. Ceramic compounds as compared to metallic compounds

  4. A.
    crystallise faster.
    B.
    resist greater tensile stress at room temperature.
    C.
    have higher melting temperature.
    D.
    are better conductor of electricity at higher temperature.

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Pressure exerted by a liquid depends upon its

  6. A.
    surface tension
    B.
    density
    C.
    viscosity
    D.
    buoyancy

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. The most detrimental impurity in high pressure boiler feed water is

  8. A.
    suspended salt
    B.
    dissolved salt
    C.
    silica
    D.
    turbidity

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Pick out the wrong statement.

  10. A.
    A soft magnetic material should have high permeability and small area of hysterisis loop.
    B.
    Poisson's ratio of high melting point metals is more than unity.
    C.
    Solders generally melt at less than 185°C.
    D.
    Steel produced by B.O.F process is ideally suited for manufacturing flat product.

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. The refractory lining of the bottom in a basic electric arc furnace is made of

  12. A.
    silica
    B.
    alumina
    C.
    magnesia
    D.
    fireclay

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. Alcohols are not suitable as diesel engine fuel because the cetane number of alcohols is

  14. A.
    very low which prevents their ignition by compression.
    B.
    very high which prevents their ignition by compression
    C.
    zero.
    D.
    none of these.

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Matte smelting is used in the extraction of

  16. A.
    lead
    B.
    zinc
    C.
    aluminium
    D.
    copper

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. Percentage of differential pressure lost in a venturimeter with a tapering of 15° may be about

  18. A.
    1
    B.
    10
    C.
    25
    D.
    50

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. Compressed dry air is used as the cutting fluid, while machining

  20. A.
    steel
    B.
    cast iron
    C.
    aluminium
    D.
    none of these

    View Answer

    Workspace

    Discuss Discuss in Forum