Home / Chemical Engineering / Stoichiometry :: Section 7

Chemical Engineering :: Stoichiometry

  1. Addition of a non-volatile solute to a solvent produces a __________ in its solvent.

  2. A.
    freezing point elevation
    B.
    boiling point depression
    C.
    vapor pressure lowering
    D.
    all (a), (b) & (c)

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The pH value of a solution is 5.9. If the hydrogen ion concentration is decreased hundred times, the solution will be

  4. A.
    basic
    B.
    more acidic
    C.
    neutral
    D.
    of the same acidity

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Hess's law of constant heat summation is based on conservation of mass. It deals with

  6. A.
    equilibrium constant.
    B.
    reaction rate.
    C.
    changes in heat of reaction.
    D.
    none of these.

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Percentage saturation of a vapor bearing gas is always __________ the relative saturation.

  8. A.
    higher than
    B.
    smaller than
    C.
    equal to
    D.
    either (a) or (b); depends on the system

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Cp is expressed in S.I. unit as

  10. A.
    J/kg.°K
    B.
    0°K
    C.
    W/m2. °C
    D.
    W/m. °K

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. Total energy at a point comprises of __________ energy.

  12. A.
    potential & kinetic
    B.
    pressure
    C.
    internal
    D.
    all (a), (b) & (c).

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. Pick out the wrong unit conversion of mass transfer co-efficient.

  14. A.
    1 lb/hr.ft3.atm. = 4.8182 kg/hr.m2.bar
    B.
    1 kg/hr.m2.atm= 0.98687 kg/hr. m .bar
    C.
    1 lb/hr . ft2 = 4.8823 kg/hr . m2
    D.
    1 kg/hr . m2 = 4.8823 lb/hr . ft2

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. "The heat capacity of a solid compound is approximately equal to the sum of the heat capacities of the constituent elements." This is the statement of

  16. A.
    Law of Petit and Dulong
    B.
    Kopp's rule
    C.
    Nearnst heat theorem
    D.
    Trouton's rule

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. A bypass stream in a chemical process is useful, because it

  18. A.
    facilitates better control of the process.
    B.
    improves the conversion.
    C.
    increases the yield of products.
    D.
    none of these.

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. 1 ata is equivalent to

  20. A.
    1 atm.
    B.
    10 torr
    C.
    0.98 Pascal
    D.
    1 kgf/cm2

    View Answer

    Workspace

    Discuss Discuss in Forum