Home / ECE / Measurements and Instrumentation :: Section 1

ECE :: Measurements and Instrumentation

  1. A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be

  2. A.
    0.004 Ω
    B.
    0.005 Ω
    C.
    0.05 Ω
    D.
    0.1 Ω

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because

  4. A.
    it loads the circuit to maximum extent
    B.
    it loads the circuit moderately
    C.
    it does not load the circuit at all
    D.
    it uses centre zero galvanometer instead of Voltmeters

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Assertion (A): A hot wire ammeter has a cramped scale.

    Reason (R): The heat is proportional to square of current.

  6. A.
    Both A and R are true and R is correct explanation of A
    B.
    Both A and R are true but R is not correct explanation of A
    C.
    A is true R is false
    D.
    A is false R is true

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Which of the following is true about an impulse voltage?

  8. A.
    It is a unidirectional voltage
    B.
    Chopped impulse flashover does not occur
    C.
    Time taken to rise is equal to time taken to fall
    D.
    RMS value is always less than 50% of average value

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Which of the following are needed both for protection and metering?

  10. A.
    Wattmeters
    B.
    Instrument transformers
    C.
    Energy meters
    D.
    Power factor meters

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. A digital frequency counter can be converted to DVM by addition of a suitable

  12. A.
    voltage controlled oscillator
    B.
    D/A converter
    C.
    power amplifier
    D.
    operational amplifier

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. A dynamometer wattmeter is connected in ac circuit. The reading will be

  14. A.
    V-A product
    B.
    average power
    C.
    peak power
    D.
    instantaneous power

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. The speed transducer using a drag cup rotor has the main advantage of

  16. A.
    very high accuracy
    B.
    low energy requirement
    C.
    cheap construction
    D.
    all of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. A voltmeter using thermocouples measures

  18. A.
    rms value
    B.
    peak value
    C.
    average value
    D.
    peak to peak value

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?

  20. A.
    Measurement of unknown voltage
    B.
    Measurement of resistance
    C.
    Measurement of unknown current
    D.
    Calibration of voltmeter

    View Answer

    Workspace

    Discuss Discuss in Forum