Home / ECE / Microwave Communication :: Section 8

ECE :: Microwave Communication

  1. Consider the following statements, SWR of a transmission line is infinite when the load is

    1. a short circuit
    2. a complex impedance
    3. an open circuit
    4. a pure reactance
    Which of the above statements are correct?

  2. A.
    1 and 3 only
    B.
    1, 2, 3
    C.
    2, 3, 4
    D.
    1, 2, 4

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. In a reflex klystron the output frequency is determined primarily by resonant frequency of cavity.

  4. A.
    True
    B.
    False

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. In TE10 mode the largest electric field in a rectangular wave guide, occurs

  6. A.
    along centre line of broad wall (i.e. x = a/2)
    B.
    along the broad wall (i.e. x = 0 and x = a)
    C.
    either (a) or (b)
    D.
    neither (a) nor (b)

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Which modes of circular wave guides have circular symmetry?

  8. A.
    TE11
    B.
    TE11 and TE21
    C.
    TE01
    D.
    TE01 and TM01

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. In rectangular waveguides the ratio of width to height is about

  10. A.
    0.5
    B.
    1
    C.
    2
    D.
    4

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. If wavelength in free space is λ0 wavelength in insulator λ, μr is relative permittivity or insulator and ∈r is relative permittivity or insulator, then

  12. View Answer

    Workspace

    Discuss Discuss in Forum


  13. In the given figure the circuits for input impedance of a microwave device with output ports match terminated. The device is

  14. A.
    E plane tee
    B.
    H plane tee
    C.
    magic tee
    D.
    hybrid ring

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Which of these statements is correct?

  16. A.
    Ridge guide is essentially a form of capacitively loaded guide.
    B.
    Ridge guide is essentially a form of inductively loaded guide.
    C.
    Ridge guide is essentially a form of resistively loaded guide.
    D.
    Ridge guide has higher power handling capacity than rectangular waveguide.

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. A rectangular waveguide has width a. Then at the cutoff frequency (with corresponding wave length λc)

  18. A.
    B.
    a = λc
    C.
    D.
    a = 2λc

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. In a rectangular waveguide cutoff wavelength for TE10 mode is 8 cm. Then cutoff wavelength for TE20 mode is

  20. A.
    8 cm
    B.
    6 cm
    C.
    4 cm
    D.
    2 cm

    View Answer

    Workspace

    Discuss Discuss in Forum