Home / ECE / Network Analysis and Synthesis :: Section 22

ECE :: Network Analysis and Synthesis

  1. For node 2 in figure, KCL equation is

  2. View Answer

    Workspace

    Discuss Discuss in Forum


  3. Which one of the following is positive real function?

  4. View Answer

    Workspace

    Discuss Discuss in Forum


  5. The dynamic impedance of an R-L and C parallel circuit at resonance is __________ ohm.

  6. A.
    R/LC
    B.
    C/LR
    C.
    LC/R
    D.
    L/CR

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. The hot resistance of a tungsten lame is about 12 times its cold resistance. Accordingly, the cold resistance of a 60 Ω, 120 V lamp is about __________ ohm.

  8. A.
    5
    B.
    240
    C.
    2
    D.
    2880

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. The response of a function is decided by

  10. A.
    the location of its zeros
    B.
    the location of its poles
    C.
    both (a) and (b)
    D.
    none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. An RL impedance function is to be synthesised in second Foster form. The proper function to be expanded is

  12. A.
    Z(s)
    B.
    sZ(s)
    C.
    1/Z(s)
    D.
    Z(s)/s

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. Ideally an attenuator pad should not change

  14. A.
    voltage level
    B.
    impedance level
    C.
    power level
    D.
    voltage, power or impedance level

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. If two networks are connected in series of individual Z parameter as Za and Zb then equivalent Z is

  16. A.
    [Z] = [Za] + [Zb]
    B.
    [Z] = [Za] [Zb]
    C.
    [Z] = [Za]/[Zb]
    D.
    [Z] = [Za] - [Zb]

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. The model of a system

  18. A.
    is unique
    B.
    depends on desired degree of accuracy
    C.
    depends on the type of analysis
    D.
    both (b) and (c)

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. Q of a coil

    1. increases with Q increasing frequency
    2. varies linearly with frequency
    3. increase with increasing frequency because R increases at high frequency
    4. decrease after the peak frequency because R increases at H.F. the correct statements are

  20. A.
    A, B
    B.
    C, D
    C.
    A, C
    D.
    B, D

    View Answer

    Workspace

    Discuss Discuss in Forum