Home / Mechanical Engineering / Automobile Engineering :: Section 3

Mechanical Engineering :: Automobile Engineering

  1. The purpose of a thermostat in an engine cooling system is to

  2. A.
    prevent the coolant from boiling
    B.
    allow the engine to warm up quickly
    C.
    indicate the coolant temperature
    D.
    pressurise the system to raise the boiling point

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The basic characteristics of a brake fluid is

  4. A.
    a high boiling point
    B.
    low viscosity
    C.
    compatibility with rubber and metal parts
    D.
    all of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. The petrol engine works on

  6. A.
    Otto cycle
    B.
    Carnot cycle
    C.
    Diesel cycle
    D.
    Rankine cycle

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. The gradient resistance to a vehicle having a mass of 980 kg moving on an incline of 10° is

  8. A.
    1.6694 N
    B.
    16.694 N
    C.
    166.94 N
    D.
    1669.4 N

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. The reconditioning process used to give cylinder bore surfaces a cross-hatch pattern, is known as

  10. A.
    honing
    B.
    porous plating
    C.
    boring
    D.
    shot peening

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. The function of a radiator fan in the cooling system is that

  12. A.
    it blows air through the radiator when necessary
    B.
    it is turned by wind force as the vehicle moves forward, and its rotation drives the water pump
    C.
    it cools the engine by blowing air onto the cylinder block
    D.
    it draws heat out of the engine compartment

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. The main function of an exhaust muffler is the

  14. A.
    optimisation of exhaust efficiency
    B.
    reduction of exhaust noise
    C.
    reduction of nitrogen oxide in the exhaust gases
    D.
    reduction of the exhaust gas volume

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. The characteristic that is enhanced by the honing of cylinder sleeves inner surface is

  16. A.
    cooling efficiency
    B.
    resistance to wear
    C.
    lubrication performance
    D.
    none of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. Instead of valves, the ports are used in case of

  18. A.
    four stroke I.C. engines
    B.
    two-stroke I.C. engines
    C.
    V-6 engines
    D.
    none of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. The starting system includes

  20. A.
    a battery, a starter, and an ignition switch
    B.
    a battery, a distributor, and an ignition switch
    C.
    a battery, a starter, and a distributor
    D.
    a distributor, a starter, and an ignition switch

    View Answer

    Workspace

    Discuss Discuss in Forum