Home / Mechanical Engineering / Automobile Engineering :: Section 4

Mechanical Engineering :: Automobile Engineering

  1. The purpose of adding pigment to the paint is that it

  2. A.
    optimises the viscosity of paint
    B.
    makes paint film hard
    C.
    gives colour and filling up effect to the paint
    D.
    none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. A laminated glass upon cracking

  4. A.
    bursts into sharp edged fragments
    B.
    bursts into granular pieces
    C.
    sandwiched layer traps the fragments
    D.
    breaks into the form of crystals

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. In a four speed four-stroke Diesel engine, the intake valve

  6. A.
    opens at T.D.C. and closes at B.D.C.
    B.
    opens at 20° before T.D.C. and closes at 35° after B.D.C.
    C.
    opens at 10° after T.D.C. and closes at 20° before B.D.C.
    D.
    none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. When the top of the wheel is tilted outward, then it is called

  8. A.
    positive camber
    B.
    negative camber
    C.
    positive caster
    D.
    negative caster

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. The purpose of transmission in an automobile is

  10. A.
    to vary the speed of automobile
    B.
    to vary the torque at the wheels
    C.
    to vary the power of automobile
    D.
    none of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. A basic difference between the spark ignition engine and the Diesel engine is that the

  12. A.
    Diesel engine compresses air alone instead of an air-fuel mixture
    B.
    air temperature ignites the fuel in the Diesel engine
    C.
    fuel is sprayed into the combustion chamber in the Diesel engine as the piston nears T.D.C. on the compression stroke
    D.
    all of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. The cam shaft in an engine is always mounted

  14. A.
    parallel to the crankshaft
    B.
    perpendicular to the crankshaft
    C.
    inclined to the crankshaft
    D.
    none of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Caster is a

  16. A.
    forward tilt of the kingpin
    B.
    backward tilt of the kingpin
    C.
    either 'a' or 'b'
    D.
    none of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. A front stabilizer bar is used to

  18. A.
    increase vehicle load-carrying capacity
    B.
    provide a softer ride
    C.
    control suspension movement and body roll
    D.
    all of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. The timing belt is attached to the camshaft pulley and

  20. A.
    timing belt drive pulley
    B.
    distributor
    C.
    radiator fan pulley
    D.
    alternator pulley

    View Answer

    Workspace

    Discuss Discuss in Forum