Home / Mechanical Engineering / Production Engineering :: Section 4

Mechanical Engineering :: Production Engineering

  1. The factor responsible for the formation of discontinuous chips is

  2. A.
    low cutting speed and large rake angle
    B.
    low cutting speed and small rake angle
    C.
    high cutting speed and large rake angle
    D.
    high cutting speed and small rake angle

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The stroke of a shaping machine is 250 mm. It makes 30 double strokes per minute. The overall average speed of operation is

  4. A.
    3.75 m/min
    B.
    5 m/min
    C.
    7.5 m/min
    D.
    15 m/min

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. The actual feed in centreless grinders is given by (where d = Dia. of regulating wheel, n = Revolutions per minute, and α = Angle of inclination of wheel)

  6. A.
    πd
    B.
    πd n
    C.
    πd n sin α
    D.
    πd n cos α

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. For fast removal of materials during grinding, a __________ grinding wheel is used.

  8. A.
    coarse grained
    B.
    fine grained
    C.
    medium grained

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Which of the following process is used for preparing parts having large curved surfaces and thin sections?

  10. A.
    Hot machining
    B.
    Ultra-sonic machining
    C.
    ECM process
    D.
    Chemical milling

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. A grinding wheel becomes glazed (i.e. cutting edge takes a glass-like appearance) due to

  12. A.
    wear of bond
    B.
    breaking of abrasive grains
    C.
    wear of abrasive grains
    D.
    cracks on grinding wheel

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. To grind brittle materials, a coarse grained grinding wheel is used.

  14. A.
    Agree
    B.
    Disagree

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Gears can be cut on a shaper.

  16. A.
    Agree
    B.
    Disagree

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. The grade of grinding wheel depends upon

  18. A.
    hardness of the material being ground
    B.
    speed of wheel and work
    C.
    condition of grinding machine
    D.
    all of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. A dynamometer is a device used for the measurement of

  20. A.
    chip thickness ratio
    B.
    forces during metal cutting
    C.
    wear of the cutting tool
    D.
    deflection of the cutting tool

    View Answer

    Workspace

    Discuss Discuss in Forum