Home / Computer Science / Computer Networking :: Networking Miscellaneous

Computer Science :: Computer Networking

  1. Protocols are

  2. A.

     Agreements on how communication components and DTE

    B.

     Logical communication channels used for transferri

    C.

     Physical communication channels used for transferr

    D.

     None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The method of communication in which transmission takes place in both directions, but only one direction at a time is called

  4. A.

     Simplex

    B.

     Four wire circuit

    C.

     Full Duplex

    D.

     Half Duplex

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Error detection at the data link level is achieved by

  6. A.

     Bit Stuffing

    B.

     Cyclic Redundancy Code

    C.

     Hamming Code

    D.

     Equalization

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Which of the following is a wrong example of network layer?

  8. A.

     Internet Protocol (IP) - ARPANET

    B.

     X.25 Packet Level Protocol (PLP)-ISO

    C.

     Source routing and domain naming-USENet

    D.

     X.25 level 2-ISO

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. The topology with highest reliability is:

  10. A.

     Bus topology

    B.

     Star topology

    C.

     Ring topology

    D.

     Mesh topology

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. "BAUD" rate means

  12. A.

     The number of bits transmitted per unit time.

    B.

     The number of bytes transmitted per unit time.

    C.

     The rate at which the signal changes.

    D.

     None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. Start and stop bits are used in serial communication for

  14. A.

     Error detection

    B.

     Error correction

    C.

     Synchronization

    D.

     Slowing down the communication

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Unmodulated signal coming from a transmitter is know as

  16. A.

     Carrier signal

    B.

     Baseband signal

    C.

     Primary signal

    D.

     None of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. How many Character per sec(7bits + 1parity) can be transmitted over a 2400 bps line if the transfer is synchronous (1 "Start" and 1 "stop" bit)?

  18. A.

     300

    B.

     240

    C.

     250

    D.

     275

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. Which one of the following network uses dynamic or adaptive routing?

  20. A.

     TYMNET

    B.

     ARPANET

    C.

     SNA(IBM's System Network Architechture)

    D.

     None of these

    View Answer

    Workspace

    Discuss Discuss in Forum