Computer Science :: Computer Networking
- To enable RIPng, which of the following would you use?
- Which of the following is true when describing a global unicast address?
-
What two multicast addresses does OSPFv3 use?
1. FF02::A
2. FF02::9
3. FF02::5
4. FF02::6 -
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
Whatsapp
Facebook
|
A.
Packets addressed to a unicast address are delivered to a single interface. |
|
B.
These are your typical publicly routable addresses, just like a regular publicly routable address in IPv4. |
|
C.
These are like private addresses in IPv4 in that they are not meant to be routed. |
|
D.
These addresses are meant for nonrouting purposes, but they are almost globally unique so it is unlikely they will have an address overlap. |