Home / ECE / Analog Electronics :: Section 1

ECE :: Analog Electronics

  1. In figure, VEB = 0.6 V, β = 99. Then VC and IC are

  2. A.
    9.3 V and 1.98 mA respectively
    B.
    4.6 V and 1.98 mA respectively
    C.
    9.3 V and 0.02 mA respectively
    D.
    4.6 V and 0.02 mA respectively

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The input impedance of op-amp circuit of figure is

  4. A.
    120 k ohm
    B.
    110 k ohm
    C.
    infinity
    D.
    10 k ohm

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit

  6. A.
    all calculations done earlier have to be repeated
    B.
    replace all calculated voltages by reverse values
    C.
    replace all calculated currents by reverse values
    D.
    replace all calculated voltages and currents by reverse values

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use

  8. A.
    surge resistor
    B.
    surge inductor
    C.
    surge capacitor
    D.
    both (a) and (b)

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. The output V0 in figure is

  10. A.
    -100 V
    B.
    -100 mV
    C.
    10 V
    D.
    10 mV

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. In a CE amplifier the input impedance is equal to the ratio of

  12. A.
    ac base voltage to ac base current
    B.
    ac base voltage to ac emitter current
    C.
    ac emitter voltage to ac collector current
    D.
    ac collector voltage to ac collector current

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. For a system to work, as oscillator the total phase shift of the loop gain must be equal to

  14. A.
    90°
    B.
    45°
    C.
    270°
    D.
    360°

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a

  16. A.
    sine wave
    B.
    square wave
    C.
    triangular wave
    D.
    (a) or (c)

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. The transistor of following figure in Si diode with a base current of 40 μA and ICBO = 0, if VBB = 6V, RE = 2 kΩ and β = 90, IBQ = 20 μA then RB =

  18. A.
    200 kΩ
    B.
    265 kΩ
    C.
    150 kΩ
    D.
    100 kΩ

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. In the amplifier circuit of figure hfe = 100 and hie = 1000 Ω. The voltage gain of amplifier is about

  20. A.
    0.33
    B.
    0.5
    C.
    0.66
    D.
    1

    View Answer

    Workspace

    Discuss Discuss in Forum