Home / ECE / Analog Electronics :: Section 2

ECE :: Analog Electronics

  1. In an amplifier the voltage gain is the ratio of

  2. A.
    output voltage and emitter resistance
    B.
    output voltage and input current
    C.
    output voltage and input voltage
    D.
    none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The critical frequency of the circuit of figure is

  4. View Answer

    Workspace

    Discuss Discuss in Forum


  5. Find resistance RB to bring transistor to threshold of saturation VCB = 0, VBE = 0.7 V, a = 0.96

  6. A.
    1.5 kΩ
    B.
    15 kΩ
    C.
    10 kΩ
    D.
    1 kΩ

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. In figure ID = 4 mA. Then VGS =

  8. A.
    4.4 V
    B.
    -4.4 V
    C.
    0.44 V
    D.
    -0.44 V

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. A typical value of gm for a FET is about 25 μs.

  10. A.
    True
    B.
    False

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. The dissipation at the collector is in the quiescent state and increases with excitation in the case of a

  12. A.
    class A series fed Amplifier
    B.
    class A transistor coupled Amplifier
    C.
    class AB amplifier
    D.
    class B amplifier

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. In following circuit, RB will be if VCC = 10 V, VS = 2 V, RC = 5 kΩ, RS = 90 kΩ, β = 50, ICE = 0, VCEsat = 0.1 V

  14. A.
    230 K
    B.
    235 K
    C.
    240 K
    D.
    250 K

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. The open loop gain of an ideal op-amp is

  16. A.
    infinite
    B.
    very high
    C.
    neither high nor low
    D.
    low

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. In following figure, what will be R1 and R2 for maximum symmetrical swing if VCSat ≈ 0. Given that RE = 200 Ω, RC = 400 Ω, VCC = 20 V, β = 99

  18. A.
    6 k
    B.
    3 k, 6 k
    C.
    9.9 k, 2.4 k
    D.
    2.4 k, 9.9 k

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. The ideal characteristics of a stabilizer is

  20. A.
    constant output voltage with low internal resistance
    B.
    constant output current with low internal resistance
    C.
    constant output voltage with high internal resistance
    D.
    constant internal resistance and constant output current

    View Answer

    Workspace

    Discuss Discuss in Forum