Home / ECE / Analog Electronics :: Section 10

ECE :: Analog Electronics

  1. In figure, current gain is

  2. A.
    a
    B.
    re
    C.
    D.

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. In the CE circuit shown in figure the slope of dc load line will be

  4. View Answer

    Workspace

    Discuss Discuss in Forum


  5. Which of the following values represents the open loop gain of typical op-amp?

  6. A.
    100
    B.
    10000
    C.
    100000
    D.
    1000000

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Which of the following configuration has low thermal stability?

  8. A.
    CB
    B.
    CC
    C.
    CE
    D.
    All have identical thermal stability

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Efficiency of class A power amplifier is very poor.

  10. A.
    True
    B.
    False

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. In an op-amp comparator, the positive or negative output is

  12. A.
    saturated
    B.
    amplifier
    C.
    unsaturated
    D.
    any of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. In logarithmic amplifiers, output voltage is equal to

  14. A.
    K.log10 (input voltage)
    B.
    K.loge (input voltage)
    C.
    input voltage
    D.

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. In a series regulated power supply circuit the voltage gain of pass transistor satisfies the condition

  16. A.
    Av → ∞
    B.
    1 << Av → ∞
    C.
    Av ≈ 1
    D.
    Av << 1

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. Occasionally a discrete amplifier user RF chokes instead of collector resistors. Such amplifiers are inherently

  18. A.
    low pass amplifiers
    B.
    high pass amplifiers
    C.
    band pass amplifiers
    D.
    none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. In oscillator circuits the energy feedback to its input terminal from output is

  20. A.
    always in phase with the input signal
    B.
    90° out of phase with the input signal
    C.
    180° out of phase with the input signal
    D.
    270° out of phase with the input signal

    View Answer

    Workspace

    Discuss Discuss in Forum