Home / ECE / Analog Electronics :: Section 20

ECE :: Analog Electronics

  1. In a JFET, gates are always

  2. A.
    forward biased
    B.
    reverse biased
    C.
    either forward or reverse biased
    D.
    unbiased

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. By connecting external resistances to a differential amplifier we can adjust

  4. A.
    voltage gain
    B.
    bandwidth
    C.
    both voltage gain and bandwidth
    D.
    none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. In a CC circuit the current gain is

  6. A.
    B.
    C.
    D.
    β

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What must be the minimum gain of the oscillator to provide oscillations?

  8. A.
    40
    B.
    60
    C.
    100
    D.
    130

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. For the circuit shown in figure low cut-off frequency is

  10. A.
    1.59 Hz
    B.
    159 Hz
    C.
    1.59 kHz
    D.
    1.59 MHz

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. In a CE amplifier the Q point is very close to saturation point on the dc load line. This results in

  12. A.
    positive clipping of collector current
    B.
    negative clipping of collector current
    C.
    both positive and negative clipping of collector current
    D.
    either positive or negative clipping of collector current

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. Class-B amplifier has less efficiency compared to

  14. A.
    class A
    B.
    class B
    C.
    class C
    D.
    class A, AB and C

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. In the amplifier circuit figure the quiescent point voltage and current are

  16. A.
    12 V, 5 mA
    B.
    12 V, 2 mA
    C.
    10 V, 2 mA
    D.
    10 V, 5 mA

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. Calculate the O/P voltage of a non-inverting constant gain multiplier with R1 = 100 kΩ, Rf= 600 kΩ, V1 = 2 volt, then O/P voltage Vo of non inverting op-amp is given by

  18. A.
    16 V
    B.
    14 V
    C.
    20 V
    D.
    15 V

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. For a BJT, β and a are related as

  20. View Answer

    Workspace

    Discuss Discuss in Forum