Home / ECE / Microwave Communication :: Section 6

ECE :: Microwave Communication

  1. Slotted line can be used for measurement of high frequencies

  2. A.
    True
    B.
    False

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. In a waveguide the dielectric region is generally

  4. A.
    air
    B.
    magnetic material
    C.
    brass
    D.
    mica

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. In directional coupler of the given figure, the terms |S14| and |S23| of scattering matrix are nearly

  6. A.
    1 each
    B.
    0.5 each
    C.
    0.1 each
    D.
    1 and 0.5 respectively

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. A line is excited by a 100 V, 200 ohm source and is terminated by 100 Ω resistance. If the voltage on line reaches steady value in 80 ns, the natural resonant frequency is

  8. A.
    100 MHz
    B.
    50 MHz
    C.
    12.5 MHz
    D.
    6.25 MHz

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. A line of length slightly longer than and open circuited at far end behaves as

  10. A.
    inductance L
    B.
    capacitance C
    C.
    L and C in series
    D.
    L and C in parallel

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. The most commonly used magnetron is

  12. A.
    cylindrical
    B.
    parallel plate
    C.
    inclined plate
    D.
    flat plate

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. The effect of earth's magnetic field on radiowaves is minimum when

  14. A.
    the electric field lines of radio waves and flux line of earth's magnetic field are in the same direction
    B.
    the electric field lines of radio waves and flux lines of earth's magnetic field are at right angles
    C.
    the electric field lines of radiowaves and flux lines of earth's magnetic field oppose each other
    D.
    both (b) and (c)

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. A line of characteristic impedance Z0 branches into two line each with characteristic impedance Z0. The refracted voltage is

  16. A.
    zero
    B.
    infinite
    C.
    equal to incident voltage
    D.
    two third of incident voltage

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. The resistance values of a PIN diode under positive bias and negative bias respectively are about

  18. A.
    a few ohms and a kilo ohms
    B.
    about 100 ohms and 1000 ohms
    C.
    about 0.1 ohm and 100 ohms
    D.
    about 1000 ohms and 10000 ohms

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. A PIN diode can be used

  20. A.
    as a shunt mounted switch
    B.
    as a series mounted switch
    C.
    both as series or shunt mounted switch
    D.
    non of the above

    View Answer

    Workspace

    Discuss Discuss in Forum