Home / ECE / Microwave Communication :: Section 6

ECE :: Microwave Communication

  1. Assertion (A): Inter-digitated geometry is widely used for microwave transistors.

    Reason (R): Tuning at input and output of transistor uses MOS chip capacitors.

  2. A.
    Both A and R are correct and R is correct explanation of A
    B.
    Both A and R are correct but R is not correct explanation of A
    C.
    A is correct but R is wrong
    D.
    A is wrong but R is correct

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. For a 1 cm x 2 cm air filled rectangular waveguide the maximum frequency should be less than about

  4. A.
    1000 MHz
    B.
    5000 MHz
    C.
    14000 MHz
    D.
    140000 MHz

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. Hollow waveguides are used as transmission lines at frequencies

  6. A.
    above 1 GHz
    B.
    above 5 GHz
    C.
    above 10 MHz
    D.
    above 1 MHz

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. If rv is reflection coefficient and VSWR is voltage standing wave ratio, then

  8. View Answer

    Workspace

    Discuss Discuss in Forum


  9. In the given figure the equivalent circuit of a T attenuator. If the condition for matched attenuator is

  10. View Answer

    Workspace

    Discuss Discuss in Forum


  11. The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large

  12. A.
    sphere
    B.
    rectangle
    C.
    square
    D.
    ellipse

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. The AM, PM, and TV broadcast frequencies are

  14. A.
    of the same order as microwave range
    B.
    much lower than microwave range
    C.
    much higher than microwave range
    D.
    either (a) or (c)

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. Assertion (A): For a reciprocal microwave junction the S matrix is symmetrical.

    Reason (R): In a symmetrical matrix Sij = Sji.

  16. A.
    Both A and R are correct and R is correct explanation of A
    B.
    Both A and R are correct but R is not correct explanation of A
    C.
    A is correct but R is wrong
    D.
    A is wrong but R is correct

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. In TE mode of waveguide Ez = 0

  18. A.
    True
    B.
    False

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. The primary constants of a transmission line are

  20. A.
    R and L
    B.
    R, L and C
    C.
    R and C
    D.
    R, L, G and C

    View Answer

    Workspace

    Discuss Discuss in Forum