Home / ECE / Analog Electronics :: Section 11

ECE :: Analog Electronics

  1. The pinch-off voltage is the drain voltage on the shorted gate drain curve above which the drain current becomes

  2. A.
    almost negligible
    B.
    very high
    C.
    almost constant
    D.
    highly variable

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. Which of the following plot can be used to show the input volt-ampere characteristics of a common-emitter configuration?

  4. A.
    VBE versus iB for constant values of VCE
    B.
    VCE versus iC for constant values of IB
    C.
    VCE versus iC for constant values of IE
    D.
    None of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. A transconductance amplifier has

  6. A.
    high input impedance and low output impedance
    B.
    low input impedance and high output impedance
    C.
    high input and output impedance
    D.
    low input and output impedance

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is

  8. A.
    100
    B.
    50
    C.
    10
    D.
    5

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. In order to protect a MOSFET against damage from any stray voltage at the gate

  10. A.
    grounding rings are provided
    B.
    terminals are shorted
    C.
    source terminal is earthed during transit
    D.
    none of these

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. A capacitor input filter relies on

  12. A.
    average detection
    B.
    peak detection
    C.
    both (a) and (b)
    D.
    neither (a) nor (b)

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. RECTIFIER : OSCILLATOR ::

  14. A.
    Capacitance : Inductance
    B.
    Series resonance : Parallel resonance
    C.
    DC : AC
    D.
    Regulation : Efficiency

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. A voltage doubler circuit uses

  16. A.
    two diodes
    B.
    two capacitors
    C.
    two diodes and two capacitors
    D.
    none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. Which amplifier will be preferred for highest gain?

  18. A.
    Darlington's pair
    B.
    Single stage amplifier
    C.
    Cascade amplifier
    D.
    Depends on the circuitry

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. Which of the following are synonymous?

  20. A.
    MOSFET and IGEFT
    B.
    FET and JFET
    C.
    JFET and MOSFET
    D.
    P-N-P and N-P-N

    View Answer

    Workspace

    Discuss Discuss in Forum