Home / ECE / Digital Electronics :: Section 7

ECE :: Digital Electronics

  1. The counter which require maximum number of FF for a given mod counter is

  2. A.
    Ripple counter
    B.
    BCD counter
    C.
    Ring counter
    D.
    Programmed counter

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. Four inputs A, B, C, D are fed to a NOR gate. The output of NOR gate is fed to an inverter. The output of inverter is

  4. A.
    A + B + C + D
    B.
    A + B + C + D
    C.
    ABCD
    D.
    ABCD

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. The content of which of the following determines the state of the CPU at the end of the execute cycle (when the interrupt is recognized)?

    1. Program counter
    2. Processor register
    3. Certain status conditions
    Select the correct answer using the codes given below :

  6. A.
    1 and 2
    B.
    2 and 3
    C.
    1 and 3
    D.
    1, 2 and 3

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. In a gate output is Low if and only if all inputs are High. The gate is

  8. A.
    OR
    B.
    AND
    C.
    NOR
    D.
    NAND

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. With on-chip decoding, n address lines can access

  10. A.
    2n memory locations
    B.
    2n2 memory locations
    C.
    2n memory locations
    D.
    n2 memory location

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. The circuit in the figure is has two CMOS-NOR gates. This circuit functions as a

  12. A.
    flip-flop
    B.
    schmitt trigger
    C.
    monostable multivibrator
    D.
    astable multivibrator

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is

  14. A.
    20 k ohm
    B.
    80 k ohm
    C.
    320 k ohm
    D.
    640 k ohm

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.

  16. A.
    5.85 V
    B.
    6 V
    C.
    5 V
    D.
    10 V

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. In the TTL circuit in the figure, S2 to S0 are select lines and X7 to X0 are input lines. S0 and X0 are LSBs. The output Y is

  18. A.
    Indeterminate
    B.
    A ⊕ B
    C.
    A ⊕ B
    D.
    C . A ⊕ B + C . (A ⊕ B)

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. The number of accumulators in 6800 are

  20. A.
    2
    B.
    3
    C.
    1
    D.
    4

    View Answer

    Workspace

    Discuss Discuss in Forum