Home / ECE / Digital Electronics :: Section 20

ECE :: Digital Electronics

  1. If we need a low noise device, we should use

  2. A.
    BJT
    B.
    FET
    C.
    thyristor
    D.
    UJT

    View Answer

    Workspace

    Discuss Discuss in Forum


  3. The principal of locality of reference justifies the use of

  4. A.
    interrupts
    B.
    DMA
    C.
    virtual memory
    D.
    cache memory

    View Answer

    Workspace

    Discuss Discuss in Forum


  5. The contents of the commands register are 23 H. Then port C

  6. A.
    is an input port
    B.
    is an output port
    C.
    is both input as well as output port
    D.
    none of the above

    View Answer

    Workspace

    Discuss Discuss in Forum


  7. Consider the following digital circuits:

    1. Multipliers
    2. Read only memories
    3. D-latch
    4. Circuits as shown
    Which of these come under the class of combinational circuit?

  8. A.
    1 and 2
    B.
    3 and 4
    C.
    1, 2 and 3
    D.
    1, 2, 3 and 4

    View Answer

    Workspace

    Discuss Discuss in Forum


  9. Which of the following bus is used to transfer data from main memory to peripheral device?

  10. A.
    DMA bus
    B.
    Output bus
    C.
    Input bus
    D.
    Data bus

    View Answer

    Workspace

    Discuss Discuss in Forum


  11. An 8085 microprocessor based system uses a 4 k x 8 bit RAM whose address in AAOOH. The address of the last byte in this RAM is

  12. A.
    OFFFH
    B.
    1000H
    C.
    B9FFH
    D.
    BA00H

    View Answer

    Workspace

    Discuss Discuss in Forum


  13. Read the following statements: Dual slope ADC provides

    1. higher speed as compared to other ADC
    2. very good accuracy
    3. good rejection of power supply
    4. better resolutions compared to other ADC for the same number of bits
    Which of the above are correct?

  14. A.
    1 and 2
    B.
    2 and 3
    C.
    1, 2, 3
    D.
    1, 2, 3, 4

    View Answer

    Workspace

    Discuss Discuss in Forum


  15. In 8085 microprocessor, how many I/O ports can be accessed by memory mapped method?

  16. A.
    8
    B.
    256
    C.
    32 K
    D.
    64 K

    View Answer

    Workspace

    Discuss Discuss in Forum


  17. The open wired circuit in the given figure works as a

  18. A.
    EX - NOR gate
    B.
    AND gate
    C.
    XOR gate
    D.
    NOR gate

    View Answer

    Workspace

    Discuss Discuss in Forum


  19. The circuit shown below is functionally equivalent to

  20. A.
    NOR gate
    B.
    OR gate
    C.
    EX-OR gate
    D.
    NAND gate

    View Answer

    Workspace

    Discuss Discuss in Forum